JavacardOS will not accept order any more, please contact our partner Feitian online Store:
https://ftsafe.en.alibaba.com/index.html

Question about ST-LINK production.

Embedded system programming,electronics DIY, ARM, Arduino, STM32, 8051, STM8,module, shield, development board.
Post Reply Previous topicNext topic
Christian
Posts: 1
Joined: Mon Feb 18, 2019 11:09 pm
Points :14
Contact:
Contact Christian

Question about ST-LINK production.

Post by Christian » Tue Feb 19, 2019 1:35 am

I have finished the basic function of my project on the STM32 platform. My question is: what is the ST-LINK is the better choice for producing in mass production at the level of about 500-1000 units or more? Any suggestions, documents, tips.

Thanks.
Top
Ethan99
Posts: 3
Joined: Sun Mar 03, 2019 11:05 pm
Points :16
Contact:
Contact Ethan99

Re: Question about ST-LINK production.

Post by Ethan99 » Sun Mar 03, 2019 11:32 pm

When in mass production, ST-LINK is not a better choice.
Maybe you can see the following document for reference:
AN2606:<STM32 microcontroller system memory boot mode>
AN3155:<USART protocol used in the STM32 bootloader>

USART is perhaps easier to do a basic experiment.
Top
Ethan99
Posts: 3
Joined: Sun Mar 03, 2019 11:05 pm
Points :16
Contact:
Contact Ethan99

Re: Question about ST-LINK production.

Post by Ethan99 » Sun Mar 03, 2019 11:53 pm

Christian wrote: ↑
Tue Feb 19, 2019 1:35 am
 I have finished the basic function of my project on the STM32 platform. My question is: what is the ST-LINK is the better choice for producing in mass production at the level of about 500-1000 units or more? Any suggestions, documents, tips.

Thanks.
For more security, SWD of ST-LINK should be disabled in a release production.
Top
Post Reply Previous topicNext topic

Return to “MCU Programming”

Who is online

Users browsing this forum: No registered users and 27 guests

JavaCard OS : Disclaimer