Page 1 of 1
Failed to connect R502 in JCIDE
Posted: Tue Dec 15, 2015 3:58 am
by kineri
I tried to connect a real smart card via
JCIDE. The smartcard reader I was using is FEITIAN
R502 reader.
But when I click "Run" icon, an error prompt pop up,as shown below.
Should I configurate something before connecting the reader? Or is this a bug in
JCIDE?
Re: Failed to connect R502 in JCIDE
Posted: Sun Dec 20, 2015 10:59 pm
by btwtiger
You can set the communication protocol to "T=0|T=1" and then try to connect the reader again.
