The exclusive promotional activities on JCOP J3H145 card and Feitian R301 Smartcard Reader are in full swing. Please check this page for details.

How to implements SPI by GPIO?

Embedded system programming,electronics DIY, ARM, Arduino, STM32, 8051, STM8,module, shield, development board.
Posts: 83
Joined: Wed Nov 04, 2015 7:23 am
Points :626

How to implements SPI by GPIO?

Post by BirdKing » Mon Jul 15, 2019 12:23 am

Hello, everyone.
Now, I want to implements SPI protocol by GPIO pins. But I'm new at this. The first thing I want know is that I should set the pin to IN or OUT for MOSI. And the same question to MISO, CLK and CSS...

Who is online

Users browsing this forum: No registered users and 1 guest

JavaCard OS : Disclaimer