The exclusive promotional activities on JCOP J3H145 card and Feitian R301 Smartcard Reader are in full swing. Please check this page for details.

Question about ST-LINK production.

Embedded system programming,electronics DIY, ARM, Arduino, STM32, 8051, STM8,module, shield, development board.
Christian
Posts: 1
Joined: Mon Feb 18, 2019 11:09 pm
Points :14
Contact:

Question about ST-LINK production.

Post by Christian » Tue Feb 19, 2019 1:35 am

I have finished the basic function of my project on the STM32 platform. My question is: what is the ST-LINK is the better choice for producing in mass production at the level of about 500-1000 units or more? Any suggestions, documents, tips.

Thanks.

Ethan99
Posts: 3
Joined: Sun Mar 03, 2019 11:05 pm
Points :16
Contact:

Re: Question about ST-LINK production.

Post by Ethan99 » Sun Mar 03, 2019 11:32 pm

When in mass production, ST-LINK is not a better choice.
Maybe you can see the following document for reference:
AN2606:<STM32 microcontroller system memory boot mode>
AN3155:<USART protocol used in the STM32 bootloader>

USART is perhaps easier to do a basic experiment.

Ethan99
Posts: 3
Joined: Sun Mar 03, 2019 11:05 pm
Points :16
Contact:

Re: Question about ST-LINK production.

Post by Ethan99 » Sun Mar 03, 2019 11:53 pm

Christian wrote:
Tue Feb 19, 2019 1:35 am
I have finished the basic function of my project on the STM32 platform. My question is: what is the ST-LINK is the better choice for producing in mass production at the level of about 500-1000 units or more? Any suggestions, documents, tips.

Thanks.
For more security, SWD of ST-LINK should be disabled in a release production.

Post Reply Previous topicNext topic

Who is online

Users browsing this forum: No registered users and 1 guest

JavaCard OS : Disclaimer